Jul 31, 2014 If you wish to get more details; check the sites linked here. Programming the remote control Method A — Fast programming with 1-digit subcode Before you start programming, you must fi nd the subcode of the set to be controlled. . Switch on the set you want to control. Turn on the product you want to control. You must enter the code corresponding to the manufacturer and the device by using one of the methods indicated in this manual.
Check of the programming: In principle, your set is ready for receiving the remote control commands. Proceeding this way will enable you to see whether the set responds or not. P ull up older posts. For this reason, we recommend that prior to attempting to programme the remote control, you try it out by means of one of the methods described in this user manual. Once you have checked this, successively program 2 separate mode keys using method D.
Direct the remote control towards the set and try to switch it off by pressing the key G. Refer to the list provided with these instructions, page I of the subcodes. The indicator lamp fl ashes to signal that this time is almost up, and then goes off. Common codes used for devices too are given, in the order of device name list in alphabetical order. Between two key presses, leave enough time for the key corresponding to the selected mode enough time to light up again about 1 second.
The remote control will then test all the codes automatically until it fi nds those that control the receiver. Switch on the set you want to control. Should the set not switch off, press key G repeatedly, until the set switches off. Check your remote control for proper functioning by performing the test described on page 2. However, method D automatic search for a code will greatly simplify the task for you.
The indicator lamp fl ashes to signal that this time is almost up, and then goes off. If the device does not turn off, you must program the remote control using one of the methods A, B, C or D described hereafter. If you wish to get more details; check the sites linked here. Entering a subcode lets the remote control test a predefi ned list of codes. It will make surf easier. Please keep this guide along with the code list provided separately , so that you can subse- quently programme your remote control for use with other sets. In this case it is only necessary to enter a code from the list that corresponds to the type of device, for example: 0603 for a Thomson satellite receiver and then to run the automatic search procedure.
Direct the remote control towards your equipment and try to switch it off by simply pressing the key G. The keys Testing the remote control before you programme it 1. Surf the site with patience. Method B — 4-digit codes programming Before you start programming, you must fi nd the code of the set to be controlled. .
. . . . .
. . . . .
. . . . . . .