Display Information on the operating conditions is displayed while the remote controller is switched on. . How to Install the Indoor Unit 3-1. Advertisement Print version Many people prefer to read the documents not on the screen, but in the printed version. In this method, the copper tubes are flared at each end and connected with flare nuts. The above actions will repeat so that the room temperature is maintained at about 86°F.
Therefore, they must be purged completely. Wire Size and Length Regulations on wiring diameter differ from locality to locality. Then bend Rear panel the tubing using a tube bender to make the attach- Hole in wall ment. . For field wiring requirements, please refer to your local elec- trical codes. This is an indoor unit only.
Table 2 Narrow Tube Wide Tube Model Outer Dia. Night Setback Mode is used for saving energy. Then lift the indoor unit and unmount. Its refrigeration capacity and energy efficiency are about the same level as the conventional refrigerant, R22. Frame Fastening Method 1 Remove the screw cover on the bottom surface.
Therefore, it is not possible to measure the coil resistance, and the following procedure should be used to check the motor. Then stop the vacuum pump. Checklist before Servicing Use a clutch-type flare tool for R410A or the conventional flare tool. Perform the trouble diagnosis by Test Run mode described on Installation Instructions of indoor unit. The Indoor unit, also known as the evaporator, is mounted inside the room, enclosed in a handsome space saving cabinet. If access to any internal part is needed, follow the steps as given below.
Installing the Unit in an Area with High Winds and in a Snowy Area Countermeasures against snow and wind Fig. Get a partner to help, and bend your knees when This air conditioning system meets strict safety and operating lifting to reduce strain on your back. Therefore, it is not possible to measure the coil resistance, and the following procedure should be used to check the motor. Wiring Instructions for the Outdoor Unit Regulations on wire size differ from locality to locality. If you move the flap by hand, the flap Some metal edges and the fins are position according to the remote controller and the actual sharp and may cause injury if. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase. When the entire amount cannot be charged all at once, charge gradually while operating the unit in Cooling Operation.
Procedure for Replacing Compressor 1 Recovering refrigerant Any remaining refrigerant inside the unit should not be released to the atmosphere, but recovered using the. Advertisement Print version Many people prefer to read the documents not on the screen, but in the printed version. Summary of the content on the page No. See Table 4 and Hole should be made at a slight downward slant to the Fig. Summary of the content on the page No. Charge additional refrigerant in liquid state only.
. Summary of the content on the page No. Power Supply Cord Insulation Clamp the grounding wire of power cord with the lead tester Fig. Prohibit If refrigerant gas leaks during the work, ventilate the room. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Use of the Flaring Method Many of the conventional split system air conditioners employ the flaring method to connect refrigerant tubes which run between indoor and outdoor units. . Follow the procedure described below to locate points of leaks and carry out repairs, then recharge the refrigerant. . The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual.