Follow steps a and b a. Therefore, the horizontal and vertical output windowswill need occasional cleaning. To activate the secondary scan pattern, press and hold the button. The following pinouts are for reference only. Make surethe power cable is plugged into the scanner. Determine checkout counter layout taking into account package flow, cable routing and power requirements. Select the Transfer Files option on the next menu and then the Send Files option.
In order to get started the unit must have a fresh battery inserted into the battery compartment. The following is a list ofCheckpoint recommended switch bank settings. The primary scan pattern is active when the scanner starts. Eight settings are available for the tone of the beep normal, 6 alternate tones and no tone plus three volumesettings. When the system is in alpha-mode, a small icon will be shown in the lower right corner of the display. Connect the other end of the PowerLink cable to the keyboard port on the host device. For the vertical and horizontal platter glass windows:1.
Normally the enter keys are used for command execution or input confirmation. Cable installation alone does not guarantee that the scanner willcommunicate properly with the host system. If there are any initial failures during this sequence of tests the scanner will beep or razz to indicate the error andan error code will appear in the diagnostic indicator display. During power up the unitbeeps 3 times. Advertisement Print version Many people prefer to read the documents not on the screen, but in the printed version. This manual tells me nothing about how to integrate it with our current inventory and how the process works once the software is installed.
It provides information about the Optimus and access to the system menu for configuring the Optimus. This mode is also referred to as the button mode. The intercharacter delay needs to beadded to the transmitted output. If an asterisk is not in the default column then the default setting is Off or Disabled. Under no circumstances should the customer attempt to service the laser scanner. The scanning operation can continue with this error active.
Pedestal Sta Summary of the content on the page No. The outlet must be located near the Summary of the content on the page No. Set time threshold for automatically power off when no Powering Off the Terminal operation is taking place during that specified period Summary of the content on the page No. Summary of the content on the page No. The scanner and host may not beconfigured for the same interface. Re-insert the Optimus unit into the cradle and upload the data to the host device.
Turn off the host device. Power up the Optimus and select the Utilities option. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. When the scanner recognizes a bar code it will exit the Blink mode. Some errors will require immediate scanner maintenance. In order to access the system module, follow the instructions below: 1. Two more new tones will be heard signifying the new setting has been stored in memory.
Summary of the content on the page No. To prevent an accidental power down, it requires about 1. Plug the opposite end into the communication port of the cradle. It is possible for the Optimus to power up without at active application. In order to get started the unit must have a fresh battery inserted into the battery compartment. Does not power up after Charge the battery and check the charging status.
Check the transformer, outlet and the power strip. Carefully remove the shipping foam around the unit. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Turn off the host device. Plug the external power supply into the power jack on the PowerLink cable. To remove the cover, press the cover release down and slide the cover away form the unit.