Remove bolts and air duct 3. And when you click on the file or icon it will count as a download. Apply Water Resistant Grease to the following points. Disconnect negative — terminal first. If level is low, add recommended oil to full level hole Max.
. Models Covered are Mercury - Mariner 9. If oil pressure is lower or higher than specification, following causes may be considered. Covers Bigfoot Big Foot and Non-Bigfoot models. If out of specification, adjust tappet clearance by changing shim.
V-6 Cylinder, Two Cycle, Direct Injected. Rotate crankshaft counterclockwise to prevent water pump impeller damage. The shim discs are easy to remove and refit. Pour recommended engine oil into oil filler opening, then install oil filler cap. Disconnect safety lanyard switch plate from emergency stop switch. Maintenance intervals should be judged by number of hours or months, whichever comes first. Remove lower gear oil drain plug before gear oil level plug and drain gear oil.
Confirm the thread size and reach when replacing the plug. Adjust to within specified range if gap is out of specification. Disconnect the safety lanyard from the emergency stop switch prior to cranking the engine. In order to be valid, the warranty registration must be completed and submitted years. Replace propeller if damage noticeably affects operation. If level is low, add distilled water only.
Remove engine oil drain plug and gasket to drain engine oil. Disconnect remote control throttle cable from throttle lever. If oil level is low, slowly inject gear oil up to the correct level. In this page you find schematic, users and instructions manuals, service manuals, technical supplement, leaf leads and other good stuff. Tighten engine oil drain plug to specified torque. When the tappets are set to the specified clearance, the engine will run without excessive noise from the valve mechanism and will deliver full power.
Replace if vanes are cut, torn or worn. Descarga nuestra manual johnson Libros electrónicos gratis y aprende más sobre manual johnson. Install compression gauge hose attachment into plug hole, then connect compression gauge hose to gauge hose attachment and compression gauge. The subsequent pages give detailed procedures. Install oil level plug before removing oil filler tube from drain hole. Para encontrar más libros sobre manual johnson, puede utilizar las palabras clave relacionadas : Johnson Repair Manual 1971-89 Outboard 1 To 60 Hp.
Move and hold throttle lever in full-open position. Loosen screw and disconnect blue lead wire from oil pressure switch. Se você observar falhas de funcionamento: Este aparelho tem uma garantia de para peças e mão de obra no país de. A short beep will be heard if cancellation is successfully finished. The anode should be periodically cleaned with a wire brush to ensure maximum effectiveness. Measure tappet clearances by inserting thickness gauge between cam and shim surface.
Your dealer laws in force you should seek professional advice. Inspect case and under panel. Start engine and allow to warm up. Also, be sure to replace spark plug if it has a broken insulator, damaged thread, etc. Attach engine tachometer to the ignition high-tension cord. Performing the scheduled maintenance is very important. This will prevent any residual fuel discharged from the cylinders being ignited by a spark discharge from the spark plug caps.