Ask a Yamaha dealer to inspect. To avoid stalling, use the proper gear and maintain a steady speed when climbing a hill. In addition, the coolant must be changed at the intervals specified in the periodic maintenance and lubrication chart. You should practice control of the throttle, brakes, shifting procedures, and turning techniques in this area before trying more difficult terrain. If you stall or roll backwards, follow the special procedure for braking described in this manual. The spring preload setting is determined by measuring distance A, shown in the illustration. When installing the wheel, reverse the removal Wheel nut torque: procedure.
Lower grease nipple ×2 1. If tion, consult a Yamaha dealer. Cover the muffler outlet with a plastic bag to prevent moisture from entering it. It contains important safety information. The tires should be set to the recom- mended pressure: Use the low-pressure tire gauge. Throttle lever work smoothly, check for the cause.
If there is any dealer inspect the brake system. Whenever possible, ride straight up hills. Pull the panel backward, and then remove 7. This, in addition to extensive research, is how Clymer repair manuals achieve an unmatched level of detail, accuracy and clarity to guide the reader through each service, troubleshooting and repair procedure. Improper tire pressure can cause loss of control. With the purchase of this Yamaha, you can now appreciate the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. The throttle should be opened amount of power you have available at a given slightly.
It must pressures to the following specifications: open smoothly and spring back to the idle position when released. Remove the nuts from the wheel. Install the bolt and tighten it. To reduce your risk of drowning or other injuries, use care when crossing through water. After extensive tests, only the tires listed below have been approved for this model by Yamaha Motor Co. Safety is an obliga- tion of the machine owner. Remove the headlight bulb holder by pushing it in and turning it counterclockwise, and then remove the burnt-out bulb.
However, it is not possible for Yamaha to test all non-Yamaha accessories, nor have any control over the quality or suitability of them. Items marked with an asterisk should be performed by a Yamaha dealer as they require special tools, data and technical skills. If you stall or roll Always use the size and type of tires specified in backwards, follow the special procedure for this manual. Since heat and deposits will cause any spark plug to slowly erode, the spark plug should be removed and checked in accor- 1. Cargo should be properly distributed and securely attached.
Remove panels A, B and C. It is advisable to have a Yamaha dealer make this adjustment. Riding on public roads can result in collisions with other vehicles. Connect the air intake duct to the throttle Air filter case holding plate bolt: body, and then tighten the clamp screw at the 7 Nm 0. Take the time to learn the basic techniques well before attempting more difficult maneuvers. This information will be needed to order spare parts from your Yamaha dealer. Follow the same procedure when shifting to 1.
Be sure that may result. To release the parking brake, move the parking brake lever in direction b. Remove the spark plug cap. Insert the tailpipe into the muffler and align 7. When fully stopped, apply the rear brake as well, and then lock the parking brake. Recommended lubricant: Lithium-soap-based grease Left side 1. When installing a front wheel, make sure its ar- row mark points toward the rotating direction.
Raise the pedal the engine by pushing the start switch. Have a Yamaha dealer adjust the position of the handlebar. You should also wear eye protection goggles or face shield , gloves, boots, a long-sleeved shirt or a jacket, and long pants. If not, have a Operating with improperly serviced or Yamaha dealer check the brake system. Eye protection, such as a face shield or goggles, may reduce the risk of foreign material getting in your eyes and help prevent loss of vision. Remove the coolant reservoir cap, and then turn the coolant reservoir upside down to empty it.